Drill Bits | Hurricane Shutters Wholesale

Drill Bits

Usually Ships in 24 Hours
0.30 LBS
Calculated at Checkout
Standard Drill bits for tapcon maxiset screw anchors
  • Use to Pre-Drill Holes for 1/4" Tapcon Screw Anchors and Panelmate Pro Anchors

  • Provides an accurate fit so anchors install quick and last long

  • Precise holes in order to achieve maximum holding power

  • Less breakage on the job

  • Increased drive and holding power when used with Panelmate Pro anchors

  • The standard drill bit is universally used for drilling smaller pilot holes in concrete, block and brick, and works seamlessly with Tapcon anchors

  • The SDS drill bit is designed for heavy-duty use in rotary hammer drills without any slippage, providing productive, high-torque drilling. The carbide tip easily drives through concrete & masonry

  • Standard Drill Bits are either 3/16" in diameter or 7/32" in diameter and come in the following lengths:

  1. 3/16 x 4 1/2"

  2. 3/16 x 5 1/2"

  3. 3/16 x 6 1/2"

  4. 7/32 x 6"

  5. 7/32 x 8"

  • The SDS Drill Bits are 7/32" in diameter and comes in 6" and 8" Lengths.