The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Drills Bits

Usually Ships in 24 Hours
0.01 LBS
Standard Drill bits for tapcon maxiset screw anchors
  • Use to Pre-Drill Holes for 1/4" Tapcon Screw Anchors and Panelmate Pro Anchors

  • Provides an accurate fit so anchors install quick and last long

  • Precise holes in order to achieve maximum holding power

  • Less breakage on the job

  • Increased drive and holding power when used with Panelmate Pro anchors

  • The standard drill bit is universally used for drilling smaller pilot holes in concrete, block and brick, and works seamlessly with Tapcon anchors

  • The SDS drill bit is designed for heavy-duty use in rotary hammer drills without any slippage, providing productive, high-torque drilling. The carbide tip easily drives through concrete & masonry

  • Standard Drill Bits are either 3/16" in diameter or 7/32" in diameter and come in the following lengths:

  1. 3/16 x 4 1/2"

  2. 3/16 x 5 1/2"

  3. 3/16 x 6 1/2"

  4. 7/32 x 6"

  5. 7/32 x 8"

  • The SDS Drill Bits are 7/32" in diameter and comes in 6" and 8" Lengths.